Search

How to Qualify PU Adhesive for Indonesian Fire-Door Production | SPC

Qualification protocol—not a customer case

How to Qualify PU Adhesive for Indonesian Fire-Door Production

Use this page as a proposed qualification workflow. It does not claim that five Indonesian OEMs switched products, that a particular test was passed, or that an adhesive alone certifies a finished fire door.

1. Confirm the compliance scope

Ask an accredited local body which Indonesian standard, edition and test configuration applies to the complete door. Record leaf construction, core, facings, frame, seals and hardware.

2. Screen the adhesive process

SPC-HF101 is a one-component door and refrigeration panel adhesive. Its public TDS lists a 40–50 minute open time at 25 °C, viscosity of 1655 mPa·s at 32 °C and cure under 4–5 hours. These are grade-level process values—not a fire-rating claim.

3. Run a parallel production trial

  1. Document incoming materials, moisture and surface preparation.
  2. Record coating weight, assembly delay, pressure, temperature and cure time.
  3. Test the bonded panel and then the complete door construction under the required method.
  4. Release production only after the customer and responsible test body accept the evidence.

4. Define support before ordering

Agree in writing on samples, batch documentation, response channel and any on-site work. This page makes no blanket service-time or travel commitment.

Next step: verify the grade on your process

Send substrate A + B, surface treatment, application method, working-time target, daily output and destination market. SPC is the product brand of Yongjia Polyurethane Co., Ltd.; puglue.com is the company website.

Open the relevant application/selection page · View the controlled TDS · Send the process on WhatsApp

Contact

Table of Contents

✓ Received — we'll reply within 24 hours.